Select Language:
If you’re experiencing issues with your M130FW printer, resetting the NVRAM (Non-Volatile Random Access Memory) can often help solve various problems. This guide will walk you through the steps to reset the NVRAM on your M130FW printer.
-
Turn Off the Printer: Start by turning off your printer. Make sure it is completely powered down before proceeding.
-
Locate the Reset Button: Find the reset button on your printer. This button is usually located on the control panel. Check the user manual if you need help locating it.
-
Press and Hold the Reset Button: After you’ve found the reset button, press and hold it down. Keep holding it for about 5 to 10 seconds.
-
Turn On the Printer: While still holding the reset button, turn the printer back on. You should continue to hold the button until you see the printer’s lights indicate that it is starting up.
-
Release the Reset Button: Once the printer has powered on and the lights stabilize, you can release the reset button.
- Verify the Reset: After the printer has completed its startup process, check to see if the issues you were facing have been resolved. If the problems persist, you may need to repeat the process or consult the user manual for further troubleshooting tips.
By following these simple steps, you can reset the NVRAM on your M130FW printer, which may help eliminate any errors or performance issues. This easy fix can save you time and hassle, getting your printer back in working order without the need for professional assistance. Remember to keep your printer’s software updated and refer to the user manual for additional support whenever needed.
ChatGPT
Perplexity
Gemini AI
Grok AI
